Copyright © 2020 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Complete Soft Top, CJ & YJ with Full Doors
Page
3
/1
0
2.
Position Windshield Channel onto vehicle.
Once in position, secure Windshield Channel
using the included (11) - #8 x ¼” Sheet Metal
Screws.
NOTE:
In some cases the holes on the Windshield
Channel will line up with existing holes. In this
case, ensure holes are not too large to install the
new screws included in the package. If holes are
to big, you must replace the included screws
with larger screws, found at any local hardware
store.
If you are replacing a hardtop, use the
Windshield Channel as a template to drill 1/8”
holes.
3.
Locate Passenger Side Belt Rail, (4) – 5/16” Torx
Bolts, (4) – 5/16” Flat Washers, and (4) – 5/16”
Tapping Plates.
Position Side Belt Rail onto vehicle and secure it
using the hardware listed in this step. The sheet-
metal has pre-drilled holes from the factory that
will line up with the Belt Rail.
Repeat this step for the opposite side.
1.
Remove existing soft top or hard top.
NOTE:
The Complete Top for 1976-1995 Jeep CJ7 and Wrangler YJ's can only be installed on
vehicles with full steel doors.