Omicron Lab OTMC 100, Руководство пользователя

Страница: 17 / 89

4.3 Mounting instructions
There are two possible ways for mounting OTMC 100 devices. Refer to the subsections below for
detailed mounting instructions.
Mast mounting using the delivered mast mounting
kit. Temporary mounting using the 1/4" BSW
(British Standard Whitworth) thread for
mounting on a stand, for example.
4.3.1 Mounting instructions for mast mounting
The mast mounting kit delivered with OTMC 100 contains the following parts:
• 1 mast clamp consisting of 2 clamping jaws and 4 fastening screws M6 x 110 with lock washers
• 2 clamping blocks and 4 fastening screws M6 x 16 with lock washers
• 1 connection pipe 20 x 300 mm
Proceed as follows:
Assemble the mast clamp and attach it to the mast as
shown in the figure.
The mast clamp is suitable for mast diameters of 25
to 70 mm.
Use a tightening torque of 5 Nm for the fastening
screws of the clamping block (1). The tightening
torque for the fastening screws of the mast clamp (2)
depends on the material and diameter of the mast.
1 2
Attach the clamping block (3) to the base plate of
OTMC 100 as shown in the figure.
Use a tightening torque of 5 Nm for the fastening
screws.
Exclusively use the two M6 x 16 screws delivered
with the mast mounting kit. Do not use longer screws.
The threaded holes in the base plate are only 9 mm
deep.
3
Mounting
OMICRON 17