![background image](http://html.mh-extra.com/html/omega/sp-010/sp-010_user-manual_737320009.webp)
9 |
P a g e
•
Device Address:
If your Smart Interface is part of a Network, enter the Network Address here. The default network
address is 1 for most devices. Please refer to the manual of your Smart Interface for more
information.
Note:
The default Device Address is 1.
•
Device IP or Port:
The COM port number that your device is connected to on your computer.
Important:
The following parameters should
NOT
be changed. These settings should
NOT
be changed unless the
configuration has been done on the interface.
•
BaudRate:
Controls bits per second
•
DataBits:
The number of ‘bits’ in each character sent.
•
Parity:
A means of checking correctness of character by adding an extra ‘bit’ to the character and setting the value
based on all the other bits in the character.
•
StopBits:
The number of ‘bits’ used to indicate the end of the character.
Once you have completed setting the communication parameters for your device, click
Finish
.
4.3
Load Cell Interface
The SP-010 measures the bridge voltage to determine the applied force using bridge characteristics provided by the user. To
configure the settings on your SP-010, follow these instructions:
Step 1:
Click the
Input Configuration Tab
in SYNC and select the
Load Cell
input type form the
Type
drop down.
Step 2:
Set the Parameters of your Load Cell to your preferred settings.
Parameter
Description
mV/V
Bridge output at full scale
Full Scale
Bridge maximum load
Impedance
Bridge Impedance
TARE (Target)
Update this parameter to TARE bridge
If the Bridge Impedance is set to 0 the SP-010 will automatically calculate the impedance on the next device reset or power
cycle.