
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
Pour the rinse aid into the dispenser, being careful not to overfill.
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
Adjusting Rinse Aid Dispenser
Th e rinse aid dispenser has six or four settings. Always start with the dispenser
set on "4". If spots and poor drying are a p roblem, increase the amount of rinse
aid dispensed by removing the dispenser lid and rotating the dial to "5". If the
dishes still are not drying properly o r are show spots, adjust the dial to the next
higher lever un til your dishes are sp ot-free. The recommended setting is "4".
(Factory value is "4".)
Increase the dose if there are drops of water o r lime spots on the dishes after washing.
Reduce it if there are sticky whitis h stains on your dish es o r a bluish film on glassware or
knife blades.
1
2
3
during the next wash.
Don't forget to re place the cap be fore you close dis hwa sher door.
Clean up any rinse aid spilled while during fillin g with an absorbent cloth to avoid excessive foaming
Detergents with its chemical ingredients are ne cessary to remove dirt, c rush dirt an d transport it out of the dishwasher.
Most of th e co mmercial qu ality deterge nts are suitable for this p urpose.
Detergents
Ther e are 3 sorts of d etergents
1.With phosphate and with ch lorine
2.With phosphate and without chlorine
3.Withou t phosphate and without chlorine