background image

Select  the  "Fan"  mode  to  allow  the  IDU  to  run  for  a  period  of 
time and dry it.
Turn off the power supply and the circuit breaker, and take out 
the battery in the remote controller.
The  internal  components of the  ODU  should be  inspected  and 
cleaned  regularly.  Please  contact  Clivet  local  air  conditioner 
customer  service  center  or  a  designated  technical  service 
center.

Complete the following steps before the air conditioner is set aside 
for a long time.

3. CLEANING AND MAINTENANCE

1. Open the air inlet grille.

3. Clean the air filter.
 Use a dust collector or water to clean the air filter.

Press with both thumbs 

at the same time.

For a four-way cassette unit, press the two grille locks with both
hands at the same time, and pull out the air inlet grille downwards.

2. Remove the air inlet grille (with air filter, see the figure below), open 
the grille downwards to about 45°, and raise it upwards to remove it.

Wipe the air outlet and panel with a dry cloth.
If a stain is hard to remove, clean it with clean water or neutral 
detergent.

Some metal edges and condenser fins are  sharp and incorrect 
handling can  cause injury. Therefore, be  careful when cleaning 
these parts.
Check the air outlets and air inlets of the ODU regularly to see if 
they are blocked by dirt or fumes.

When the filter is too dusty, clean it with a soft brush and neutral 
detergent, and dry it in a cool, shady place.

4. Put the air filter back.

5. Perform  the  above  mentioned  steps  1  and  2  in  reverse  order  to
install and close the air inlet grille, and connect the control box lead to 
the corresponding electrical wire connector of the master unit.

For safety reasons, always turn off the air conditioner and turn 
off the power before cleaning the air conditioner.
For air conditioners with auxiliary heaters, the auxiliary heater 
is secured between the wind turbine and the heat exchanger 
of  the  IDUs  using  screws  and  the  minimum  gap  with  the 
flammable  surface  is  12  mm.  The  user  is  prohibited  from 
disassembling  and  repairing  the  part.  Otherwise,  a  fire  or 
other dangers may occur. 

WARNING

Disconnect the control box lead and electrical wire connector 
of the master unit.

CAUTION

The  air  filter  can  filter  dust  and  other  particles  in  the  air.  A 
blocked  air  filter  can  result  in  reduced  performance  of  the  air 
conditioner. When the air conditioner is  used often, remember 
to clean the air filter regularly.
If the IDU is installed in dusty places, increase the frequency of 
cleaning the air filter screen.
If the air filter is severely stained and difficult to wash, replace it 
(optional accessory).

CAUTION

Do not use gasoline, benzene, volatile agents, decontamination 
powder and liquid insecticides. Otherwise, the air outlet or panel 
may de-color or deform.
Do not expose the inside of the IDU to moisture, as it may result 
in electric shock or fire.
When cleaning the air guide with water, do not scrub it violently.
If the air conditioner is used without the air filter screen, dust will 
be deposited in the air conditioner because it is not separated 
from the indoor air, which will cause faults.

CAUTION

Check  the  air  inlet  and  outlet  of  the  ODU  and  IDU  after  long 
periods  of  use  to  see  if  they  are  blocked;  if  an  inlet/outlet  is 
blocked, clean it immediately.

CAUTION

Clean with a dust collector with the air inlet surface upward.

Clean with water with the air inlet surface downward.

Method of cleaning the air outlet and panel

Maintenance

ODU

8

Содержание OTEC IECS-D Series

















Отзывы: