EN | Instruction Manual
WWW
• This appliance shall not be used by
children aged less than 8 years. This
appliance can be used by children
from 8 years and above and persons
with reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if they
have been given supervision or
instruction concerning use of the
appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Keep the appliance and
its cord out of reach of children aged
less than 8 years. Cleaning and user
maintenance shall not be made by
children unless older than 8 and
is supervised.
• By ignoring the safety instructions,
the manufacturer cannot be held
responsible for the damage.
• If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
• Never move the appliance by pulling
the cord and make sure the cord
cannot become entangled.
• The appliance must be placed on a
stable, level surface.
• The user must not leave the device
unattended while it is connected to
the supply.
• This appliance is only to be used for
household purposes and only for the
purpose it is made for.
• To protect yourself against an electric
shock, do not immerse the cord, plug
or appliance in the water or any other
liquid.
CONTROLS
1. Oscillation knob
2. Head adjustment screw
3. Speed adjustment buttons
ASSEMBLY
• Fit the base by pushing it into place on
the underside of the fan and secure in
place by using the screws provided.
• Unscrew the rear locking ring from the
motor shaft in anti-clockwise direction.
• Set the rear cage and fit it well on the
two position holes and make sure
these holes are properly put through
the holes on the rear cage.
• Hold the rear cage and screw the rear
locking ring into the motor front cover
in a clockwise direction.
• Install the fan blade onto motor shaft
and fit the fan blade lock cap.
• Loosen the screw and nut on the
bottom of the rear cage.
• Open front cage clips and position
onto rear cage ensuring the screw at
bottom is aligned between both.
• Tighten screw and nut.
• Close the cage clips over both front
and rear cage.
VE-5834UK / VE-5835UK
1
2
3
CONTROLS
ASSEMBLY
SAFETY
