Omega OCC64TZTGG, Инструкция по эксплуатации

Страница: 10 / 13

7
OPERATING INSTRUCTIONS
Child Lock
The child lock function is used to lock the appliance in a complicated, multi-step process. Child lock (and unlocking)
is only available in S-Mode.
First, must be pressed until the buzzer sounds, then and must be pressed simultaneously for at least 0.5
seconds, but no longer than 1 second. Following this, touch to activate the child lock.
All four heater displays will show “ L ” as confirmation.
If the minute minder timer is still running, it will proceed until “ 00 ” is reached and the timer will beep. After
confirmation of timer completion, the appliance will be fully locked. None of the buttons can be used as long as the
appliance is locked.
Child lock can be deactivated in the same way that it is activated. After pressing , a beep is heard. Press
and
simultaneously for at least 0.5 seconds, followed by pressing only. As confirmation for successful unlocking,
“ L ” will no longer be displayed.
Touch Control Safety Functions
The following safety functions are available to avoid unintended operations.
Sensor Safety Cut-Off
Button monitoring is included to prevent the appliance from unwanted button operation. In cases where one or
more buttons are pressed for longer than 12 seconds, the buzzer will sound for ten minutes to indicate an incorrect
operation. For example, an object may be placed on a button, or there could be a sensor failure and so on.
The safety switch-off will cause the hob to go into S-mode and all heater displays will flash “ F ”. If there is no
incorrect operation present, both the visual and audible signals will disappear.
If residual heat is present, “ H ” will be displayed on all other heater displays.
Over Temperature Switch-Off
Due to the controls being very close to the heater in the middle of the front of the hob, it can occur that an
incorrectly placed pot is not sensed by the sensor safety cut-off therefore heating up the hob to a very high
temperature. This makes the glass and the buttons dangerous to touch.
To prevent the hob control unit from damage, the controls constantly monitor the temperature and switch off if
overheating occurs.
This will be indicated by the letter “ t ” in the heater display until the temperature decreases.
Once the temperature has dropped, the “ t ” in the heater display will disappear and the hob control unit will revert
back into S-Mode. This means that the user can reactivate the appliance by pressing .