Omega OCC64TZTGG, Инструкция по эксплуатации

Страница: 8 / 13

5
OPERATING INSTRUCTIONS
The hob is controlled by pressing the appropriate electronic button. Each button pressed is followed by a buzzer
sound.
1. Heater display
2. Activate/Deactivate heater
3. Heat setting decrease
4. Heat setting increase
5. Decimal point
6. Key lock indicator
7. Key lock
8. On/Off
Mode Descriptions
Stand-By-
Mode
S-Mode
Mains supply is applied to the
hob control and all heater
displays are off or a residual
heat display is active.
Operating-
Mode
B-Mode
At least one heater display
shows a heat setting between
´ 0 ` and ´ 9 `.
Lock Mode VR-Mode The hob control is locked.
Switching the Appliance On and Off
• If the appliance is in Stand-By mode, it is put in Operating mode by pressing the On/Off button for at least
1 second. A buzzer will sound to indicate the successful operation.
• A “ 0 ” will appear on all heater displays and all decimal points corresponding to the heaters will flash (1
second on, 1 second off).
• If there is no operation within 10 seconds, all heater displays will switch off.
• If the displays do switch off, the heater will be sent into Stand-By mode.
• If is pressed for more than 2 seconds (in Operating mode), the appliance will switch off and will enter S-
Mode again. The appliance can be switched off by pressing at any time; even if other buttons are pressed
simultaneously.
• If there is any residual heat from a heater, this will be indicated in the corresponding heater display.
Selecting a Heater
If a single heater is chosen with the corresponding Activate/Deactivate Heater Button , the decimal point of the
heater display will flash. For the selected heater, you can set the heat level between 1 and 9 by pressing the Heat
Setting Buttons or .
The buttons must be pressed within 3 seconds of selecting a heater, otherwise the heater selection will be erased
and the heat setting decimal point will disappear. If there is no further operation within 10 seconds, the heater
reverts back to S-Mode.
The heat setting can always be changed by pressing or . The available settings are between 1 and 9.
Each button operation or each display change is accompanied by a buzzer sound.
1 2
3 4 5 6 7 8