![background image](http://html2.mh-extra.com/html/omega/obos605b/obos605b_instruction-manual_5152456014.webp)
10
Accessories
The Wire Grid for Deep Trays
Make sure the wire grid is correctly placed within a deep tray. It is
recommended
to use this accessory for grilling steaks, meatballs and similar food.
The Shallow Tray
The shallow tray is best used for baking pastries. Put the tray into any rack
and push it to the end to make sure it is correctly placed.
The Wire Grid
The wire grid is best used for grilling or for processing food in oven-friendly
containers.
WARNING
Place the grid to any corresponding rack in the oven cavity correctly and
push it to the end.
You can use glass containers, cake pans and special oven trays suitable for use in your oven (available in kitchenware
shops). Pay attention to the information given by the supplier for use of this cookware. The information given below
should be implemented for enamelled containers.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer or if the
tray is used to collect the dripping juices of the foods during the grill operation, deformation might be observed on the
tray over time due to high temperatures forming during the cooking/baking operation. This is a normal, physical state
that results during the heat transfer. Do not leave a glass tray or container in a cold environment immediately after
cooking in them. Do not place them on cold and wet surfaces. Ensure that they slowly cool off by placing them on a
dry piece of cloth or wooden board, otherwise, the glass tray or container might break. If you are going to use the large
wire oven rack/grill, insert a tray into one of the lower racks to collect fat or oil. To make cleaning easier, add some
water into this tray. In a grilling operation, use the shelf in position 11 or 12.
Each wire grid and tray comes with a built-in safety feature to help minimise them being accidentally pulled fully out.
This comes in the way of a “step”, positioned part
-way in from the rear of the accessory.
To fit them into the oven, push the wire grid or tray part way into the oven until the step “catches”, then angle the part
over the step & fully insert. To remove, repeat the operation in reverse.
13
Cleaning
NOTE: Cleaning and maintenance operations must only be carried out when the oven is cool.
The appliance should be disconnected from the power outlet or turned off at your isolation
switch before commencing any cleaning process.
Cleaning the oven exterior
Before starting to clean your oven, be sure that all control buttons are off and your appliance has cooled off.
Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enamelled and painted parts of
your oven. Use cream cleaners or liquid cleaners, which do not contain particles. As these cleaners may
damage the surfaces, do not use caustic creams, abrasive cleaning powders, rough wire wool or hard tools.
In the event of any excess liquids spilling over your oven surface during cleaning, clean up immediately so
as to prevent possible damage to the enamel or metal surface. Do not use steam cleaners for cleaning the
oven.
Cleaning the interior of the oven
Make sure to unplug the oven before starting to clean it. You will obtain best results if you clean the oven
interior while the oven is slightly warm (the oven should not be operating). Wipe your oven with a soft piece
of cloth (e.g. dish cloth) dampened with warm soapy water after each use, rinse cloth in warm water then
wipe oven again and then finish by wiping with a dry cloth. For a complete cleaning process, use dry and
powder type oven cleaners, following the oven cleaning product’s instructions.
Troubleshooting
If the oven does not operate:
•
The oven may be unplugged from the power source or switched off at the power source.
•
The household fuse has blown or household power supply is off.
•
The Timer (if available) may not set correctly.
If the oven does not heat:
•
The heat may not be set correctly with the oven’s temperature setting.
If the interior lighting lamp does not light:
•
The lamps are defective. If they are defective, you can change them following the instructions
within this manual.
Cooking (if lower-upper part does not cook equally):
•
Control the shelf locations, cooking period and heat values according to the manual.
Unit smoking when first used:
•
This is a result of protective oils being removed and is to be expected with a first use.
Oven fan is still running even though knobs in off position:
•
The cooling fan has activated to cool down the control; this is normal and may stay on for some
time.
Clock Flashing on Display
•
Power failure or interruption
If you have any further problems with your product, please call your Authorised Service Centre.
14
11
Accessories
Easy Fix Wire Rack
•
Insert the accessory to the correct position inside the oven.
•
Take care removing cookware and/or accessories out of the oven. Hot meals or accessories can
cause burns.
•
The accessories may deform with heat. Once they have cooled down, they will recover their
original appearance and performance.
•
Trays and wire grids can be positioned on any level from1 to 5.
****Accessories may vary depending on the model purchased.
Содержание OBOS605B
Страница 1: ...1 Instruction Manual OMEGA OVEN OBOS605B...