Omega HH931T, Руководство пользователя

Страница: 32 / 49

Service Information
4-4
14. The UUT will display the current voltage reading.
15. Allow the UUT displayed voltage to stabilize before proceeding.
16. Press UUT to automatically adjust the UUT voltage reading to the Applied
Voltage, ±0.001 mV.
a. If the UUT displayed voltage is not within ±0.001 mV of the Applied
Voltage, press
until the UUT displayed voltage is within ±0.001
mV, adjusting as close to the Applied Voltage as possible.
17. Press UUT . The display will change to rES1 [2, 3 …] showing the actual
measured value saved in the previous step.
18. Press UUT again. This will increment to the next CAL value.
19. Repeat Steps 12 through 18 for each remaining value in Figure 15 below. For
single channel UUTs, omit Channel 2 values.
a. For two channel UUTs using the single-ended Copper Mini-TC Cable,
disconnect the cable from the UUT Channel 1 input, and reconnect the
cable to the Channel 2 input after completing CAL4 in Figure 15 below.
Repeat Step 11.
C
HANNEL
UUT D
ISPLAY
A
PPLIED
V
OLTAGE
(mV)
1
CAL1 -10
CAL2 ( 75
CAL3 -10
CAL4 ( 30
2
CAL5 -10
CAL6 ( 75
CAL7 -10
CAL8 ( 30
Figure 15: Gain Alignment Values
20. Remove the copper cable from the DC Voltage Source and UUT.
Cold Junction Compensation Alignment
21. Connect one end of the Type E 6 Thermocouple Cable to the UUT Channel 1 input.
a. For two channel UUTs using the Split Thermocouple Cable, connect the
miniature thermocouple connector of one leg to the UUT Channel 1
6 If substituting another thermocouple type, use the appropriate Thermocouple Cable for the selected
thermocouple type.