![background image](http://html.mh-extra.com/html/omega/freedom-400/freedom-400_owners-manual_736717023.webp)
Installation Insert Page 12
if the alarm is armed (including while the alarm is activated), and will draw current
from the vehicle's electrical system only if an attempt is made to start the vehicle.
CONNECTION: To interrupt the vehicle's starter circuit, the starter wire must be
located and cut. It is recommended that this connection be done as close to the
ignition switch as possible. Use a voltmeter, not a test light, to find the correct wire,
which is the wire from the ignition switch to the starter solenoid.
CAUTION! Avoid
the airbag circuit! Improper use of a test light can cause deployment of the airbag,
which may result in bodily injury! Test lights can also damage on-board computers
and associated sensors. The starter wire will read +12 Volts only when ignition
key is in "start" position (cranking the engine). Cut this wire at a suitable location.
Confirm that this is the correct wire by turning the ignition switch to the "start"
position. The starter should not engage.
Relay
Optional
Starter
Interrupt
Orange / Orange
✄
White:
To Starter
Red: To
Ignition
Switch
Cut wire
Freedom-400
Control Unit and
Siren Assembly
Starter
Ignition
Switch