![background image](http://html1.mh-extra.com/html/omega/dp606a/dp606a_user-manual_4064327007.webp)
Installation and Operating Conditions
2
Section 2 - Installation and Operating Conditions
This Instrument is marked with the international Caution symbol. It is important to
read and follow the Setup Guide before installing or commissioning this device. The
Guide contains important information relating to safety and EMC.
The instrument is a device protected in accordance with UL 61010:2010 Electrical
Safety Requirements for Electrical Equipment for Measurement, Control and
Laboratory. The device has no power-on switch. Installations must include a switch
or circuit breaker that is compliant to IEC 947-1 and 947-3. It must be suitably
located to be easily reached and marked as the disconnecting device for the
equipment.
WARNING
: Do NOT connect AC power to your device until you have completed
all input and output connections. This device is a panel mount device protected in
accordance with Class I of EN 61010 (115/230 AC power connections), Class III for
the DC power option (9-36Vdc). It must be installed by a trained electrician with
corresponding qualifications. Failure to follow all instructions and warnings may
result in injury.
Use Copper conductors only, minimum 20 AWG, UL Rated, for power and outputs.
Insulation must be rated for at least 85ºC and 600V.
This device is not designed for use in, and should not be used for, patient-connected
applications.
Safety:
• Do not exceed the voltage rating on the label located on the device housing.
• Always disconnect power before changing signal and power connections.
• Do not operate this instrument in flammable or explosive atmospheres.
• Do not expose this instrument to rain or moisture.
EMC:
• Whenever EMC is an issue use shielded cables.
• Never run signal and power wires in the same conduit.
• Use signal wire connections with twisted-pair cables.
• If EMC problems occur Install Ferrite Bead(s) on signal wires close to the
instrument.
WARNING
:
Failure to follow all instructions and warnings is at your own risk and
may result in property damage, bodily injury and/or death. Omega Engineering
is not responsible for any damages or loss arising or resulting from any failure to
follow any and all instructions or observe any and all warnings.
CAUTION: Risk of electric shock. Disconnect all power sources before servicing.
2