![background image](http://html2.mh-extra.com/html/omega/dp26-rtd/dp26-rtd_user-manual_4044223022.webp)
3.2 MAIN BOARD POWER JUMPERS (Continued)
S2 jumpers are for sensor break indications:
*
S2A jumper is not used
*
S2B jumper is for positive sensor break on input 1 (i.e. heating)
*
S2C jumper is for positive sensor break on input 2 (i.e. heating)
*
S2D is not used
S3 jumpers are used for the following (refer to Table 3-1):
*
To enable or disable the front panel push-buttons
*
To allow for an extremely low resistance load for analog output
*
To disable the
MENU
button
*
To perform calibration procedure
Test pins TP1 - TP11 are for testing purposes. Do not use as reading errors may
result.
Table 3-1 S3 Jumper Functions
Jumper
Description
S3-A
Install to enable front panel push-buttons.
Remove to disable all front panel push-buttons
S3-B
Removed. Install for factory calibration only.
S3-C
Normally removed. Install for analog voltage output when load is less than
1 Kohm impedance. Care should be taken when installing this jumper.
S3-D
Removed. Not used.
S3-E
If installed without S3-B, the
MENU
button locks out.
While in run mode, if you press the
MENU
button, the display shows
“LOCK".
14
Содержание DP26-RTD
