Page 43
The Echo will play a musical melody; this is the Start Melody which
plays upon remote starting. One of five melodies may be chosen now.
Each press of the button changes to the next melody, note that the
LCD screen displays “S” and a numeral, which is the melody number.
When the desired musical tone has been the last one played
Press and release the button
..
press and release the button
P
The Echo will play another musical melody; this is the Stop Melody
which plays when remote start engine run period ends. There are
five different melody choices which can be made.
Each press of the button changes to the next melody, note that the
LCD screen displays a numeral only, which is the melody number.
When the desired musical tone has been the last one played, you may
Press and release the button
..
P
leave the Echo undisturbed for 12 seconds, until it chirps once
OR
press and release the button to scroll
back through the programmable features.
The Time’s “Minutes” will flash, and may be set now.
Press and release the button
to advance the minutes or
..
press and release the button
to reverse the minutes.
...
When the minutes are correct
press and release the button
P
• While the Echo programming must be “scrolled” through, programming mode
can be exited at any point within the menu by simply not pressing any but-
tons for 12 seconds. The Echo chirps once when it exits programming mode.
• If the “MUTE” vibrating operation is selected, turning off the chirps, the
remote starting melodies are also replaced by vibration.
• The previous also applies to the musical melodies when programming- if the
Arming
the Crime Guard system turns on the antitheft protection, disables the
vehicle’s starter and locks the doors (provided an interface is installed). Once the
system is
Armed
, any intrusion attempt will
Activate
it, sounding the siren and
flashing the lights to attract attention.
Disarming
the system turns off the
protection, allowing normal use of the vehicle.
There are three methods of Arming the security system:
1- The first method is to use the transmitter or transceiver, by pressing and
releasing its “Arm/Lock” button. The system must not be in Alarm Valet
Mode (page 21), and the vehicle’s ignition switch must be off. Every press
of the “Arm/Lock” button arms the system, even if it is already armed.
2- The second method is to press and release the transmitter or transceiver’s “II”
button twice within 5 seconds. This is “Silent Arming”.
3- The third method is Last Door Arming, which configures the system to
automatically arm every time you exit the vehicle. This method of arming is
programmable, and may be used or not used as desired.
Page 6
USING YOUR CRIME GUARD SYSTEM
To Arm the System:
Press & Release the “Arm/Lock” Button ( ) on Either
U
REMOTE ARMING BY TRANSMITTER OR TRANSCEIVER
* An optional doorlock interface must be installed
THE DOORS WILL LOCK*
THE PARKING LIGHTS
FLASH TWICE
TO CONFIRM
ARMING
THE SIREN CHIRPS TWICE
TO CONFIRM ARMING
Upon Arming the System will:
• The siren will chirp twice (or four times if a zone is bypassed) unless the silent
arming procedure is followed.
• The parking lights will flash twice (or four times if a zone is bypassed).
• The doors will lock*.
