Omega National EVO Скачать руководство пользователя страница 6

Страница: 6 / 7

Now the unit needs the U-Proﬁ le Top Guide installed. Please

note that the top and bottom Guides look similar but are not

interchangeable. Measure and locate and mark the center line

where the top U-Proﬁ le Guide is to be installed. Locate the top

U-Proﬁ le Top Guide and install with the oval slot on the guide

positioned towards the front of the Pull-Out Pantry unit. The U-

Proﬁ le Top Guide must be placed so the front edge of the guide

is positioned behind the face frame of the cabinet, so the posi-

tion of the end of the slide needs to be against the inside edge

of the Pull-out Pantry front/back panels,

The Bottom U-Proﬁ le Guide must be removed from the Lower

Slide assembly by tapping the U-Guide forward as you hold the

Lower Slide. Once it is removed, locate the elongated screw

hole, as that is the front of the slide. The Bottom U-Proﬁ le Guide

needs to be mounted to the center line of the bottom shelf of the

Pull-Out Unit, at a position that has the front end of the U-Proﬁ le

Guide positioned against the inside edge of the Front Panel.

This U-Proﬁ le Guide is attached to the bottom of the Pull-Out

Pantry unit with #8 X 5/8 Pan Head Phillips Screws in three

locations.

Form OME-074, 01/2009

©Omega National Products

Install Wire Fences into the holes on the shelves and in the bot-

tom making sure to seat them ﬁ rmly into the holes. This should

be done before installing the shelves in the unit.

Reassemble the front/back panels to the top and bottom taking

care to get the screws started in the holes you have previously

drilled in the top and bottom. Use the #8 x 1 3/4" Flate head-

screws.

Screw the dowel screws in the front and back panels at the de-

sired shelf height and push the self down ﬁ rmly onto the dowel

to seat the shelf.

Содержание EVO







