3
PREPARATION
Assembly
Always secure the handle into the handle sleeve by means of the bolt lock washer and nut provided. Tighten securely
to prevent accidental removal of handle while in use.
Before Use
1. Verify that the product and application are compatible, if in doubt call Omega Technical Service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, turn the release valve (handle knob):
a.
Clockwise
until firm resistance is felt to further turning. This is the ‘
CLOSED
’ release valve position used to
raise the saddle.
b.
Counter-clockwise
, but no more than 1/2 turn from the closed position. This is the ‘
OPEN
’ release valve position
used to lower the saddle.
4. With saddle fully lowered and release valve fully closed, pump the operating handle. If lift arm responds immediately,
jack is ready for use. If jack does not respond, follow
Bleeding/Venting Trapped Air
instruction below.
5.
For Air Operated models 22051C & 22101C
, Pour a teaspoon of good quality, air tool lubricant into the air supply
inlet of the lift control valve. Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
NOTICE:
Air Operated models are equipped with the popular 1/4" NPT air coupler. When installing a different
air coupler of your choice, ensure that thread tape or compound is used when servicing connections. To ensure
dependable, trouble free operation an in-line air dryer and oiler is recommended.
6. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with Omega
authorized replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (Step 3b. above) and with saddle fully lowered, locate and remove the
oil filler plug/screw. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within
the reservoir. Proper oil level will vary from just covering the ram cylinder to 3/16” above it as seen from the oil filler
hole. Reinstall the oil filler plug/screw.
!
WARNING
• Study, understand, and follow all
instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
• Do not move or dolly the vehicle while on the
jack.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
To avoid crushing and related injuries:
•
Never work on, under or around a load supported
only by hydraulic jack.
•
Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
!
WARNING
