2
Figure 1 - Typical Long Chassis Jack Nomenclature (22051C shown)
SAFETY AND GENERAL INFORMATION
Save these instructions.
For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use.
Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.
PRODUCT DESCRIPTION
Omega Long Chassis Hydraulic Service Jacks are designed to lift, but not support, one end of a vehicle. Immediately
after lifting, loads must be supported by a pair of appropriately rated jack stands. Air actuated function available for
Models 22051C & 22101C.
Air actuated units require at least 7.8 CFM @ 110 - 175 PSI. A minimum of 150 PSI air
pressure is required to raise rated capacity load.
SPECIFICATIONS
Model
Capacity
Jack Size ( L x W x H)
Min. Height Max. Height Saddle Dia.
22050C/22051C
5 Ton
57-3/4" x 17" x 7-5/8"
7"
27"
6-1/2"
22100C/22101C
10 Ton
54-3/4" x 20" x 12-3/4"
7"
27"
7-3/8"
Handle Position Lock
Release Valve
(Handle Knob)
Saddle
Foot Pedal
Oil Filler Plug/Screw
(reference parts drawing
for location)
Handle
Front Wheel
Rear Caster
Lift Control Valve
(for Air Actuated models only)
Handle Sleeve
Grease Fitting
