Omega Engineering High Speed Load Cell Interface Card..., Руководство пользователя

Страница: 31 / 86

30
c. Get a single reading of:
weight, A/D or temperature:
. Get weight (after Filter2, not rounded to resolution).
? Get weight (after Filter2, rounded to resolution).
> Get A/D reading after Filter1.
< Get A/D reading after Filter2.
T Get temperature
d. Analog output: Read & write voltage:
@ Gets the analog output voltage (in Volts).
v x <c/r>
(lower case v)
Sets the analog output voltage to x Volts.
The analog output voltage is m
easured at pin 12 of CONN6
with respect to pin 13 which is ground.
e. Digital Outputs: Write outputs:
a Turn on Output1 if Manual
A Turn off Output1 if Manual
b Turn on Output2 if Manual
B Turn off Output2 if Manual
c Turn on Output3 if Manual
C Turn off Output3 if Manual
d Turn on Output4 if Manual
D Turn off Output4 if Manual
f. Digital Outputs: Read outputs:
O
(upper case o)
Card returns a string of the form ‘ xxxx <c/r>’, where x is
either “1” or “0” representing the status of the 4 output
opto relays OUT4,OUT3,OUT2,OUT1 respectively.
g. Digital Inputs: Read inputs & toggling counter:
I
(upper case i)
Card returns a string of the form ' xxxx <c/r>’, where x is
either “1” or “0” representing the digital input status of
IN4,IN3,IN2,IN1 respectively.
i
Gets a 16 bit ‘toggling counter’. The ‘toggling counter’
increments each time when input #2 is toggled
.