OMEGA ALTISE
REMOTE CONTROL OPERATION
1.
lnstall two “AAA” (not included) batteries by sliding the bottom panel of the battery body.
2.
The Remote Control Power button is labelled as such. All the functions performed with the Remote Control
work similarly to the Manual Controls.
3.
When changing modes or setting the timer, it is recommended to have the unit in non-oscillation mode and the
remote control preferably aligned to the LCD panel. This will enable better communication between the remote
control and the main unit. The change in function is confirmed by a beep by the main unit. Always check the
LCD of the main unit to confirm that you are in the correct mode (or have set the correct time).
IMPORTANT: as per the requirements of the approval regulations on safety, when the unit receives the instruction
from the remote control precisely, the working status of the unit will be updated with the status shown on the remote
control. This will ensure that the unit's working status is kept the same as the remote control's working status at that
time.
LCD Display
Touch
Controls
Battery Body
GETTING STARTED
1.
TURN THE UNIT ON (POWER)
: Turn the heater ON as per MANUAL OPERATION instructions.
2. SET THE FUNCTION YOU WANT (MODE)
: Pressing the ’MODE’ button on the remote control will set the
heater into different FUNCTIONS or MODES. Your heater has 4 modes: COOL FAN, LOW HEAT, HIGH
HEAT and AUTO. (See figures below and on the next page).
DISPLAY ON REMOTE CONTROL
COOL FAN MODE
- The heating element is turned off and the unit is
operating with the fan only. This mode is
indicated by FAN on the LCD. The UP and DOWN
buttons are disabled in this mode.
