8
Installation
(Machine should only be installed by a qualified technician and in compliance with local codes).
The electrical installation of the workplace should be equipped with power surge full protection, which should
then be adjusted to the technical specifications of your particular unit (see below).
UNPACKING AND POSITIONING
Always keep the machine in a vertical position. Take the machine out of its box. Remove the knee lever (and
the upper lid screws for E models) from the inside of the barrel and set them in their proper positions. Do not
use the knee lever to move the machine. The machine comes with two fixed (non-castor) wheels in the front
and two plastic anti-vibration legs in the back; lift the back part of the machine using the transport handle and
move the machine to the desired location (two people are necessary for moving the heavier H42 and H52
models). Do not raise the filler/stuffer too high when moving it since it could tip over, causing personal injury.
Place the machine on a level surface. Should the machine wobble, adjust the anti-vibration legs until it is
perfectly stable and level. The machine should be placed so that the plug is easily accessible.
IMPORTANT:
Remove the protective transport cap on the oil inlet (marked OIL) and replace it with the
depressurized oil cap/dipstick enclosed with the machine. Also make sure that the air holes located at the base
of the barrel are totally clear; if not, the piston will not function properly.
Technical Specifications
92 LB. CAPACITY UNITS
Model
SS-ES-0042-PAS
SS-ES-0042-PASM
HP
2.5 HP
Capacity
92 lbs. / 41.7 kgs.
Electrical
208V/60/3
220V/60/1
Weight
527 lbs. / 239 kgs.
Item Number
13757
13758
114 LB. CAPACITY UNITS
Model
SS-ES-0052-PAS
SS-IT-0052-PASM
HP
2.5 HP
Capacity
114 lbs. / 51.7 kgs.
Electrical
208V/60/3
220V/60/1
Weight
610.7 lbs. / 277 kgs.
Item Number
13759
17146