Omcan Santos 62, Инструкция по эксплуатации

Страница: 16 / 40

16
Troubleshooting
The LCD screen shows "LID OPEN":
• Close the safety hood lid (8).
The LCD screen shows "READY":
• Switch the appliance off then on again.
• After powering up the 6 key diodes should light up quickly and the screen display "READY".
• If not, check the connections on the cable connecting the
control panel to the electronic module (this operation must be carried out by a qualified person).
The blade does not rotate:
• Check that there are no foreign bodies stuck in the jar.
• Check the condition of the drive system (motor and blade).
The appliance stops after the motor has overheated, “OVER TEMP”:
(the motor unit is hot)
• Put the On / Off switch (4) to the 0 position and unplug the appliance.
• Wait for the motor to cool down (20 to 45 minutes) then press the On / Off switch (4) (position 1).
The appliance stops as a result of an overload.
The LCD screen does not light up:
A motor overload can occur if there is an excessive quantity or something too hard in the jar.
Under these circumstances, either the thermal protection or the excess current protection may be activated
and stop the appliance operating. If the appliance is hot, refer to the section “The appliance stops as a result of
motor over-heating”).
Otherwise:
• Turn off the electric power supply (unplug the mains power cord (10)).
• Move the On / Off switch (4) to the 0 position.
• Under the appliance (fig. O), press the button (25) to reset the excess current protection. If the button does
not remain in the “reset” position, allow the appliance to cool down before repeating the operation.
The appliance stops further to an overload “OVERLOAD”:
A motor overload can occur if there is an excessive quantity or something too hard in the jar.
• The recipe is not appropriate for the quantity and consistency.
• Reduce the quantity.