8
Installation and Operation
Maintenance
• DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void warranty.
The unit must be close enough to the electrical supply so that extension cords are never used.
•
The cooler should always be plugged into its own dedicated circuit with a voltage rating that matches the
rating plate. This provides the best performance and also prevents overloading wiring circuits which could
become a fire hazard from overheated wires.
• Never unplug your cooler by pulling on the power cord. Always grip the plug firmly and pull straight out from
the outlet.
•
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use
a power cord that has cracks or abrasion damage along its length or at either of its ends.
•
When removing the cooler away from the wall be careful not to run over or damage the power cord.
NOTE: Wiring diagram can be referenced by removing the front louvered grill, and looking on the
inside cabinet wall.
PLUG IN THE COOLER AND THE COMPRESSOR IS READY TO OPERATE.
• Excessive tampering with the control could lead to service difficulties. Should it ever become necessary to
replace the temperature control it should be ordered from your dealer or recommended service agent.
LIGHT SWITCH LOCATION:
The light switch is located at the left side of rear grille.
NOTE: If the unit is disconnected or shut off, wait five (5) minutes before re-starting unit.
RECOMMENDATION: Before loading product the unit should be run for 2 to 3 hours. This allows
confirmation that the electrical wiring and installation are correct and no shipping damage has
occurred.
Condensers accumulate dirt and dust and require cleaning every 30 days. Dirty condensers result in
compressor failure, product loss, and lost sales -- which are not covered by warranty.
Air is pulled through the condenser continuously along with dust, lint, grease, etc. If you keep the condenser
clean you will minimize your service expense and lower your electrical costs. The condenser requires
scheduled cleaning every days or as needed. A dirty condenser can result in non-warranted part and
compressor failures and product loss.
Proper cleaning involves removing debris from the condenser by using a soft brush or vacuuming the
condenser with a shop vacuum or using CO2, nitrogen or pressurized air.
If you cannot remove the debris adequately please call you refrigeration service company.
