Omcan MX-IT-0080-M, Инструкция по эксплуатации

Страница: 15 / 40

15
Maintenance
tension. Here we provide instructions on how to change the tension of the drive belts the spiral and the bowl.
For the procedure on how to check if the tension is correct, please consult the instructions provided by the
supplier/ manufacturer.
DRIVE BELTS TO THE SPIRAL
Wear anti abrasion gloves and foot protection with reinforced toe. Please look at Figure 12: Remove the head
cover (Pos. 1) to access the belt housing if you need to adjust the tension; Remove the Pos. 3 to replace the
belts. The Pos. 1 is secured by 4 screws, Pos. 2; The item in Pos. 3 is secured by 3 screws (Pos. 4). At the
end of the works, make sure to bring all parts (Pos. 1 and 3) in their original position and secure them with their
original hardware.
ADJUSTMENT OF THE TENSION OF THE SPIRAL DRIVE BELTS
Look at Figure 13 to adjust the tension of the belts in Pos. 1:
• Release the four screws in Pos. 2, so that the plate Pos.3 can slide.
• Release the lock nut Pos. 4.
• Use a hex wrench to undo the screw in Pos. 5; As you do this, the plate in Pos. 3 with the motor and the
pulley (Pos. 6) slides and changes the tension of the belts in Pos. 1.
• Adjust the tension of the belts in accordance with the instructions of the reference manufacturer.
• When you are done, lock the nut in Pos. 4.
REPLACING THE SPIRAL DRIVE BELTS
Look at Figure 13 to replace the drive belts to the spiral:
• Release the belts in Pos. 1.
• Pull the belts out.
• Fit new belts in to replace the old ones making sure that the fit perfectly in their grooves.
• Adjust the tension of the belts in accordance with the instructions of the reference manufacturer.
• When you are done, lock the nut in Pos. 4.
IMPORTANT! To ensure the best performance of the machine and longer service life of the belts it is crucial
to replace all drive belts, not just some.
ADJUSTING THE TENSION OF SPIRAL DRIVE BELTS
Look at Figure 14:
TO ADJUST THE TENSION OF THE BELTS IN POS. 1:
• Release the four screws in Pos. 2, so that the plate Pos. 3 can slide.
• Use a hex wrench to undo the screw in Pos. 4; As you do this, the plate in Pos. 3 with the motor and the
pulley (Pos. 5) slides and changes the tension of the belts in Pos.1.
• Adjust the tension of the belts in accordance with the instructions of the reference manufacturer.
• When you are done, lock the screws in Pos. 2.4.