05
NOTE
Due to turbulence generated when machine is ON do not turn it ON
without the Lid Nº01 (Pic.01). The processing time depends on the
kind of product.
IMPORTANT
NEVER SWITCH THE MACHINE ON WITHOUT LOAD IN IT
BECAUSE IT WILL CAUSE IRREPARABLE DAMAGES.
IMPORTANT
It is not recommended to blend products without the addition of
any liquid, otherwise it will overheat and damage the Cup seal.
3.3 Discharging Procedures
To discharge processed product from Blender Models proceed
as follows:
1- Turn machine OFF.
2- Remove Lid Nº01 (Pic. 01).
3- Press Lock Pedal Nº07 (Pic. 01) down.
4- Tilt Cup Nº02 (Pic. 01) holding its handle and discharge
processed product as needed.
3.4 Cleaning
The new Blenders cup has stamped ribs that facilitate cleaning.
Wash the Lid Nº01 and the Cup Nº02 (Pic. 01) with water and neutral
soap. Wipe up the other parts with a damp cloth.
IMPORTANT
Never do cleaning with machine plugged in. Always unplug
machine before cleaning. When washing inside the Cup be careful
with the blade.
10
4.6 Maintenance
4.6.1 Danger
Any maintenance with the machine in working situation is
dangerous. TURN IT OFF BY PULLING THE PLUG OFF THE SOCKET
DURING MAINTENANCE.
IMPORTANT
Always unplug the machine when emergency cases arise.
4.7 Advice
Electrical or mechanical maintenance must be done by qualified
personal for such operation.
Person in charge has to be sure that the machine is under TOTAL
SAFETY conditions when working.
5
Analysis and Problems Solving
5.1 Problems, causes and solutions
The High Performance Tilting Blenders were designed to operate
with the need of minimum maintenance but the natural wearing caused
by long use of the equipment may occasionally cause some malfunctions.
If such problem occurs with your Blender refer to Table 02 in which
the most common situations are listed with recommended solutions.
Table - 02
Problems
Causes
Solutions
*Lack of power.
* Problem in the electric circuit
of the machine.
* Check if machine is
plugged in and if there is
power in the power supply
source.
* The machine does not turn
on..
* Cup is leaking.
* Damaged seal.
* Call technical assistance.
* Call technical assistance.
