Omcan IC-CN-0016, Инструкция по эксплуатации

Страница: 11 / 26

11
Installation
Operation
4. Pour 1 gallon of water into the ice storage bin to check leaks at all drain connections and at the nut of the
drain water hole. Tighten any connections or nuts that leak.
IMPORTANT: poor drainage will cause a high rate of ice melting in the ice storage bin.
INSTALLATION TYPES
This ice maker has been designed to be enclosed (as under a cabinet). It can also be free-standing or built-in
(sealed to the floor). In every case, there must be adequate air space around the unit for ventilation purposes
(see diagrams on page 6).
Enclosed Installation:
An enclosed installation will allow you to install the ice maker under a cabinet or in a kitchen cabinet provided
the required clearance space around the ice maker is respected. You must follow the stated instructions for:
• Electrical requirements.
• Water supply.
• Leveling the ice maker.
Free-standing Installation:
The ice cube machine can be installed to be free-standing in any place you desire provided you have access
to a water supply. This installation has the same requirements as an enclosed installation, plus you must also
follow the stated instructions for:
• Electrical requirements.
• Water supply.
• Leveling the ice maker.
Built-in Installation:
If this method of installation is chosen, it will still be necessary to allow adequate ventilation space around the
unit. The following additional items must be observed.
1. Place the ice maker in front of the installation location. Remove the feet and place the machine on the floor
or on a platform depending on your installation requirements.
2. The water supply line must be plumbed before connecting to the ice maker.
3. Turn on the main water supply and tap. Check for water supply connection leaks. Tighten every connection
(including connections at the water inlet).
4. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice maker.
5. Push the ice maker into position.
6. Seal all around the cabinet to the floor with an approved caulking compound.
FINAL CHECK LIST BEFORE OPERATION
1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?