Omcan DW-CN-1210, Инструкция по эксплуатации

Страница: 7 / 16

7
Operation
Ensure the device is turned off.
• Connect the device to a single grounded outlet.
• Fill the water reservoir for the GN Pans.
Note: Never use the appliance without water in the tank, or the food will burn and the appliance will
overheat and may get damaged.
Fill the tank with water to a level between the “min” and “max” marks on the inside of the tank.
MAINTAINING WATER LEVELS
• The appliance will beep when the water level is too low. Switch off the power (0).
• Remove the GN pans while wearing safety gloves. Then add water carefully to prevent hot water from
splashing out.
Note: Always keep the water level between the “min” and “max” levels during operation. Do not let the
heater run while the tank is empty.
THERMAL CUT-OUT RESET
• This appliance is fitted with a thermal cut-out safety feature. Should the temperature exceed safe levels the
appliance will automatically cut the power.
• Allow the appliance to cool for 30-45 minutes.
SETTINGS
1. Press button: the set temperature is displayed.
Press or button to modify and store the displayed value.
Press button to exit the adjustment and display inside temperature of the unit.
If no other button is pressed within 10 seconds, the internal temperature will be displayed.
2. Light: Press button, it turns on; press again, it turns off.
3. Heating Indicator: During heating, the LED is on; when the internal temperature is constant, the LED is off.
• Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30°C-90°C / 86°F-194°F.
• The temperature inside of the hot display can be read from the front display.
• Put the foods in appropriate containers before placing them inside the hot display.
• Some of the device parts become very hot, always use safety gloves when placing or removing foods.
• The foods are kept warm at the temperature set by you previously.
• Switch on the inner light when required using the light switch of the device.
• Disconnect the device from the power socket when the device is not in use.