Omcan BS-IT-1651, Инструкция по эксплуатации

Страница: 9 / 24

9
Operation
7. Once the operation is finished, position the switch to OFF
(Figure 22).
IMPORTANT
If the bandsaw is in function and an unexpected power failure occur, the machine will stop immediately
(Figure 23) . When the power returns, the machine will not work even though the switch is in the ON position.
To restart, turn the switch to OFF and then to ON (Figure 24) .
THERMIC SAFETY DEVICE
WARNING: This machine is fitted with motor thermic safety device. If the motor stops after a long use, wait 10-
20 minutes (the time necessary to reduce the motor temperature).
Start again by following these instructions:
1. Re-position the switch to OFF (Figure 22) .
2. The safety device resets itself automatically (Figure 25).
3. Position the switch to ON to turn on the machine (Figure 26) .
SAW BLADE DIRECTION CONTROL
For the machine with three-phase motor, check the rotation of the blade as follows:
1. Switch the motor on briefly and make sure that the blade must rotate in a clockwise direction (Figure 26) .
2. Turn the switch to OFF .
3. If the rotation is an a counterclockwise direction, disconnect the plug and reverse the wires in the plug
(Figure 27).
4. If the machine is fitted with a plug with self-contained phase inverter, use a screw driver to press and rotate
it through 180° in order to automatically swap the phases. Re-connect the plug and check the rotation of
the blade (Figure 28) .
Maintenance
The bandsaw must be frequently cleaned, any product residue will putrefy and will cause pollution and
infection of products that will be subsequently work. The machine has been designed to make cleaning easy.
COMPONENTS REMOVAL
1. Wear protective gloves.
2. Open the blade protection door (Figure 29).
3. Remove the blade according to the procedure as described in the Installation Section: Saw Blade Removal .
4. Remove the central blade guide (Figure 30).
5. Remove the feed table (Figure 31).
6. Lift up and take off the bottom wheel (Figure 32).