Omcan BS-IT-1651, Инструкция по эксплуатации

Страница: 7 / 24

7
Installation
• Use 2 M10 studs long enough to ensure a fixing of at least 15 mm on the machine, with 2 large washers
and 2 nuts.
INSTALLATION CASE B
The bandsaw must be mounted horizontally on a stable, robust and anti-skid base
suitable to support its weight ( refer to Technical Specifications section ).
INSTALLATION CASE C
• Lay down the machine, fix the two legs and the drilled plate, and the bandsaw
using the supplied four screws and four washers.
• With the help of two people, assemble the stand to the bandsaw, lift the machine
and adjust the feet so that it is steady.
*Stand is optional.
SAW BLADE REMOVAL
1. Wear protective gloves.
2. Remove the tyrep that blocks the product pusher at the saw blade. (Figure 1)
3. Open the protective door.
4. Turn the blade tensioning device so that the top wheel is raised. (Figure 2)
5. Remove the saw blade.
(Figure 3)
ATTENTION: Position the saw blade in a safe place.
PRELIMINARY CLEANING
Before assembling, clean off the protective oil from the machine and all components.
Follow the instructions indicated in the Maintenance section.
COMPONENTS ASSEMBLY
Feed plate
6. Insert the fixed plate on the four dowels. (Figure 4)
7. Insert the blade guide. (Figure 5)
Saw blade
8. Wear protective gloves.
9. Turn the blade tensioning device lever so that the top wheel is raised. (Figure 6)
IMPORTANT:
The blade must have the characteristics described in the Technical Specifications section in
order to
avoid
any damage to the machine. The average length has a maximum tolerance of ±10 mm. If it
is over these limits the blade cannot be mounted or stretched.
10. Check that the saw teeth of the blade in the cut zone is positioned down and towards the operator. Position
the blade on the two wheels and that it is guided by the top and bottom blade guides. (Figure 7)
11. Tension the blade by turning the tensioning lever. An internal device automatically adjust the correct tension
INSTALLATION CASE C
INSTALLATION CASE B