![background image](http://html.mh-extra.com/html/omcan/46500/46500_instruction-manual_736096013.webp)
13
Operation
AUTOMATIC DEFROSTING
There is no need to defrost the Beer Dispenser. Defrost water collects and passes thru the drain outlet in the
rear wall into a tray located above the compressor, where it evaporates.
NOTE: If the unit is unplugged,power lost, or turned off; you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the Beer Dispenser may not start.
CONVERTING TO AN “ALL REFRIGERATOR”
1.
Turn off the control knob to the “OFF” position.
2. Close the main valve on the CO2 cylinder.
3.
Close the secondary shut-off valve on the regulator pipe.
4. Close the connection between the beer keg and the keg coupler.
5.
Drain any remaining beer from the lines.
6.
Disconnect the beer line and CO2 air line from the keg coupler.
7.
Remove the beer keg.
8. Remove the keg coupler.
9. Disconnect the air line from the CO2 cylinder.
10.
Remove the CO2 air line from cabinet plug.
11. Replace the air line rear cabinet plug.
12. Remove the beer tower. Also pull the beer line thru the top of the cabinet.
13. Replace the top cabinet plug.
14. Adjust temperature as desired.
CHANGING THE REVERSIBLE DOOR
This Beer Dispenser has a door that can be set to open from the left or right side. The unit is delivered to you
with the door opening from the left side. To reverse the opening direction, please follow the instructions below.
Caution: To avoid personal injury to yourself and/or property, we recommend that someone assist you
during the door reversal process.
1.
Undo the three screws in each bracket using the Phillips screwdriver.
2.
Remove the screws and bracket. Place to one side.
3.
Slide the fridge door down about 15cm (6”) and off the top hinge pin and lift away from the freezer.
4.
Using the flat bladed screw driver remove the pin from the top bracket. Replace it in the hinge bracket on
the opposite side.
5. Remove the screw from the side of the fridge where the bracket is to be re-fitted.
6.
Slide the fridge door back on to the top hinge, making sure it’s the right way up. Screw the bottom hinge
into place on the new side.
7.
Check that the door is aligned horizontally and vertically and that the seals are closed on all sides before
finally tightening the bottom hinge. Re-adjust the leveling feet.
Содержание 46500
Страница 14: ...14 Operation ...
Страница 16: ...16 Parts Breakdown Model BC CN 0152 46500 ...
Страница 17: ...17 Parts Breakdown Model BC CN 0152 46500 ...
Страница 19: ...19 Electrical Schematics Model BC CN 0152 46500 ...