Omcan 31502, Инструкция по эксплуатации

Страница: 4 / 20

4
Safety and Warranty
Warnings
The operator has to be well familiar with the position of ON/OFF Switch to make sure the Switch is easily
accessible when necessary. Before any kind of maintenance, physically remove plug from the socket. Provide
space for a comfortable operation thus avoiding accidents. Water or oil spilled on the floor will cause additional
hazards. Make sure the floor is clean and dry. Before giving any manual command (switch, buttons, turn keys
or lever) be sure the command is the correct one. Check this manual for further details if necessary. Never
use a manual command (switch, buttons, lever) unadvisedly. If any work is to be made by two or more people,
coordination signs will have to be given for each operation step. Every step of the operation shall be taken only
if the sign has been made and responded.
Advices
In case of power shortage, immediately turn the machine OFF . Use recommended or equivalent lubricants, oils
or greases. Avoid mechanical shocks as they may cause failures or malfunction. Avoid penetration of water,
dirt or dust into mechanical or electrical components of the machine.
DO NOT MODIFY
original characteristics
of the machine. DO NOT REMOVE, TEAR OFF or MACULATE ANY SAFETY or IDENTIFICATION LABELS
stuck on the machine. If any label has been removed or is no longer legible, contact your nearest dealer for
replacement.
Safety Procedures and Notes Before Switching Machine ON
IMPORTANT: Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON. Be
sure to be familiar with the instructions and that you have understood all information contained in this
manual. If you have any questions contact your supervisor or your nearest Dealer.
Danger
An electric cable or electric wire with damaged jacket or bad insulation could cause electrical shocks as well as
electrical leak. Before use, unplug and check conditions of all wires and cables.
Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every function and operational
procedure have to be very clear to the operator. Contact your nearest Dealer for further questions. Any manual
command (switch, button or lever) shall be given only after being sure it is the correct one.
Precautions
The electric cable has to be compatible with the power required by the machine. Cables touching the floor or
close to the machine need to be protected against short circuits.