Omcan 31502, Инструкция по эксплуатации

Страница: 6 / 20

6
Installation
Operation
01 - Motor
02 - Pedal Lock.
IMPORTANT: Before doing any maintenance to the machine switch it OFF and unplug it.
Starting
The Blender is activated by turning the On/Off Switch Nº03 (Pic.01) to ON position.
Operating Procedures
The High Performance Tilting Blender works at high speed (approximately 3.500 rpm, 50Hz). To feed it
proceed as follows:
1. Remove the Lid Nº01 (Pic.01).
2. Put product inside the Cup Nº02 (Pic.01) with the machine switched OFF .
3. Place the Lid Nº01 (Pic.01) back on top of the Cup and switch the machine ON .
NOTE: Due to turbulence generated when machine is ON do not turn it ON without the Lid Nº01
(Pic.01). The processing time depends on the kind of product.
IMPORTANT: NEVER SWITCH THE MACHINE ON WITHOUT PRODUCT IN IT BECAUSE IT WILL CAUSE
IRREPARABLE DAMAGES.
IMPORTANT: It is not recommended to blend products without the addition of any liquid, otherwise it
will overheat and damage the Cup seal.
Picture 2
Pre Operation
First of all check if the Blender is firm on its position. Check if Motor (Nº01) is perfectly fitted on the Lock Pedal
(Nº02) as shown on Picture 2.