16
Scroll to
CAT SETTINGS
(up or down)
and touch
SET.
Scroll to your TCVR family (up or down)
and select baud rate (left or right), then
press
SET.
Or select
NO CAT
and press
SET
.
We recommend to use CAT connection always when possible, because in such a case
has permanent information about the transmit frequency and is immediately ready for transmitting.
With setting NO CAT the detects transmit frequency from the input signal. With the input
signal frequency changing the PA automatically reacts and tune itself to optimal output parameters.
Tuning takes abt. 1sec. inside the band, abt. 2 sec if band is changed.
If you choose
YAESU
or
ICOM
NEW,
after
SET
pressing you will go to deeper
level which allows you to select specific
type of TCVR. See the following picture
for
ICOM NEW
selection, for example.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.