19
Connect your transceiver to the same grounding system of your shack carefully!
Use minimum length of cables and make sure that the connections are both physically and electrically sound.
With poor grounding, you may risk damaging to your equipment, having problems with TVI/BCI or your
transmitted signal may be distorted.
4.2.
Coaxial Cable
The output of the transceiver is to be connected to the input of the amplifier via RG58 or similar cable. For the
connection between the power amplifier and the antenna, Belden 9913 or similar coaxial cable
suited for high
power
is recommended. Both the INPUT and OUTPUT N sockets with Teflon insulation are used.
4.3.
Control Cable
Control cable maintains TX / RX switching of the PA (TX GND). The cable must be shielded. On the side of the
power amplifier a CINCH-socket is used. On the side of your transceiver you have to use a socket suitable for this
transceiver. During transmitting the middle pin is connected to the ground.
Содержание OM1002+
Страница 5: ...5 6 2 Fuses 38 6 3 Cleaning 39 7 Block Diagram 40 8 Timing 41...
Страница 12: ...12 RF Output See Note RF Input Grounding Point Mains Plug Power Supply Cooler inside...
Страница 25: ...25 5 3 Setup Menu Touch SETUP on the screen Setup menu is displayed Touch LANG...
Страница 40: ...40 7 Block diagram...
