Olympus VG190, Инструкция по эксплуатации

Страница: 25 / 78

25
EN
Drive Sets the sequential shooting function.
o
Single
One frame is shot each time the shutter button is pressed.
j
Sequential
The images are taken sequentially while holding down the shutter for up to 200
frames.
c
High-Speed1
The camera takes sequential shots at approximately 1.5 frames/sec.
d
High-Speed2
The camera takes sequential shots at approximately 15 frames/sec.
Image size Sets the number of recording pixels.
 4608×3456 Suitable for printing pictures over A3 (11×17 in.).
4 3200×2400 Suitable for printing pictures up to A3 (11×17 in.).
3 1920×1440 Suitable for printing pictures up to A4 size (8.5×11 in.).
7 640×480 Suitable for using pictures on emails.
Aspect Sets the horizontal-to-vertical ratio of images.

4:3 Change the horizontal-to-vertical ratio to 4:3 when taking pictures.
P
16:9
Change the horizontal-to-vertical ratio to 16:9 when taking pictures.
Q
3:2 Change the horizontal-to-vertical ratio to 3:2 when taking pictures.
 1:1 Change the horizontal-to-vertical ratio to 1:1 when taking pictures.
●
In certain shooting modes, some functions cannot be set. Refer to “List of settings available in each shooting
mode” (p. 57)
●
The image sizes are the examples when the aspect ratio is set to [

].
Registering one touch white balance Registering one touch white balance
Select [

One Touch 1] or [

One Touch 2], face the camera toward a piece of white paper or other white
object, and press the

button.
●
The camera releases the shutter and the white balance is registered. When the white balance was
previously registered, the registered data is updated.
●
The registered white balance data will not be cleared by turning off the power.
●
Perform this procedure under the light where the pictures will be actually taken.
●
When the camera settings are changed, the white balance must be registered again.
●
When the white balance cannot be registered, check that the white paper fi lls the screen, and then
perform the procedure again.