Olympus UWIT-Y0001-RX, Руководство по эксплуатации

Страница: 40 / 62

36
5.2 Connection of the Wireless Transmitter and Receiver
UWIT-Y0001-TX, UWIT-Y0001-RX INSTRUCTION MANUAL
Ch.5
CAUTION
• If multiple pairs of Wireless Transmitters and Receivers are to be used in adjacent
areas, the connection between the paired Wireless Transmitter and Receiver may
not complete, or the Wireless Transmitter may establish connection to the incorrect
Receiver (cross-talk). To avoid connection issues or cross-talk when multiple
Wireless Image Transmitter Units are installed, select different Channels and/or
turn off other Unit(s).
• When the Wireless Transmitter is turned off after the Wireless Transmitter and
Receiver are connected, the Wireless Receiver automatically searches a Wireless
Transmitter which is ready to connect. If the Wireless Receiver detects another
Wireless Transmitter which is ready to connect, they may connect automatically.
Operate as below to reconnect with the original Wireless Transmitter.
NOTE
• A Wireless Transmitter can connect to only one Wireless Receiver at a time.
• When the Wireless Transmitter or Receiver is turned OFF after connection has
been established, the Wireless Transmitter search same Receiver automatically
when turn ON. If the Wireless Receiver is ON and ready to connect, the Wireless
Transmitter connects to it automatically.
5.2 Connection of the Wireless Transmitter and
Receiver
1
Prepare the Wireless Transmitter and Receiver to be connected, and turn them ON.
2
Press and hold the SELECT button of Wireless Transmitter for about 1 second.
The Wireless Transmitter will seek connection to the Wireless Receiver when the
SELECT button is pressed and held for about 1 second. Ensure that the Wireless
Transmitter and Receiver have the same channel selected. To change the Channel, press
and hold the SELECT button again until the intended channel blinks.
3
The CH light will blink during the connection process. The CH light will be steady once
the Wireless Transmitter and Receiver are connected.
If CH light continues to blink and connection cannot be established, please refer to
Chapter 7, “Troubleshooting”.