10
3
Operating procedures
This section describes the basic operating procedures of each portion.
Set the main switch A to (ON).
Rotate the light intensity adjustment knob B toward the scale 5 (arrow
direction) to increase the brightness or rotate it toward the scale 0 to
decrease the brightness.
If you set the light intensity level to scale 0, the light is
not emitted, but the power of the LG-LSLED is ON (The
indicator
C
is ON). To turn OFF the power, set the main
switch
A
to (OFF).
1
2
NOTE
A
B
C
2
Before replacing the filter with another filter, set the power to (OFF) and make sure that the filter
slider is fully cooled down in order to prevent looking at LED light directly.
· The filter is not provided.
· The filter with a diameter of 28 mm and a thickness of 2 mm can be attached.
· Use the optional 28LBA15 (LBA filter) if you want to change to the light bulb color.
CAUTION
TIP
Remove the cap that covers the distal end pf the light guide before turning ON the main switch.
As the cap absorbs the light, heat damage, fire or burns may be caused.
WARNING
1
A
A
Remove the filter slider A from LG-LSLED.
1
Attach the LBA filter B to the filter slider A in the following procedure.
Push the filter slider C of the filter slider in arrow direction.
Insert the bottom of the filter B into the filter slider as follows.
Fit in the top of the filter B .
When cleaning fingerprints and oil stains attached to
the filter, slightly moisten a piece of cleaning paper with
commercially available absolute alcohol and wipe them
off with it.
2
NOTE
B
C
1
Turning ON the main switch and adjusting the brightness
2
Attaching the filter (Optional)
