20
CX22LED
}Prepare one eyepiece micrometer disk (diameter 20.4 mm, thickness 1
mm) and two 20.4-RH reticle holders (available as 2-piece set).
The field number becomes 19.6 when the reticle holders are used.
If you are using WHC15X or WHC15X-H, please purchase the micrometer
with 19mm diameter and 1mm thickness.
}As the helicoid adjustment is not available for the eyepieces other than
WHC15X-H, if your eye is poor in eyesight and cannot focus the micrometer,
use eyeglasses to correct your vision.
1. Remove both eyepieces by loosening the clamping screw using a
small flat-blade screwdriver.
2. Hold the micrometer disk @ with the surface with indications facing down
and place it into a reticle holder ².
Be careful not to leave dirt on the micrometer disk, as it
will be noticeable during observation.
3. Screw the reticle holder ² containing the micrometer disk @ into the
bottom of an eyepiece.
Be sure to screw in all the way by hooking your nail into the notch
3
on the holder at the end.
4. Screw the other reticle holder, alone, into the other eyepiece in order to
align the field number.
5. Attach the eyepieces again, and tighten the clamping screw.
4
Using the Eyepiece Micrometer Disk (Optional)
(Fig. 22)
Fig. 22
²
@
3
Attachment
}When the cord hanger (CX22LED-CH) is attached on the back of the
microscope frame, the power cord and AC adapter can be wound around
it for storing.
1. Align the hooks ² of the cord hanger @ with the cord hanger mounting
position
3
, insert the cord hanger, push it firmly against the microscope
frame and slide it down to lock it.
5
Cord Hanger CX22LED-CH
(Figs. 23 to 29)
Fig. 23
²
@
3
CAUTION
Fig. 24
Storage
1. Insert the connector @ of the power cord firmly into the input connector
² of the AC adapter (Fig. 24).
}Be sure to unplug the power cord from the outlet in advance.
²
@
