Olympus CAMEDIA AZ-2 ZOOM, Руководство для продвинутых пользователей

Страница: 155 / 177

Part of the image is too dark.
The picture displayed on the monitor is out of focus.
The picture’s colors look unnatural.
155
If you encounter problems
9
Appendix
Possible cause Corrective action
Ref.
Page
Set the white balance appropriate to the lighting
source.
Include something white in the picture, or shoot
using the fill-in flash mode
.
Adjust the white balance according to the light
source.
Hold the camera correctly, keeping your fingers
and the strap away from the lens.
Use focus lock to focus on the subject and then
shoot.
Select a different flash mode (not flash off
).
When shooting with the flash mode set to flash
off
, the shutter speeds decrease. Stabilize the
camera or hold it steady.
Hold the camera steady, and press the shutter
button gently. Camera movement is likely to
occur at slower shutter speeds. During night
shooting or shooting with the flash set to flash off
mode
in low light condition, stabilize the
camera or hold it steady.
If the subject is closer than 30 cm (11.8"), use
the super macro mode.
Clean the lens. Use a commercially available
blower brush and then wipe with the provided
camera cleaner to remove dust. Mold may form
on the lens surface if the lens is left dirty.
Install the OLYMPUS Master.
Press the POWER switch to turn the camera on.
Indoor lighting affected
the picture’s color.
No white in the picture.
The white balance setting
is wrong.
The lens was partly
blocked by your finger or
the strap.
A subject unsuited to AF
was taken.
The flash was set to the
flash off mode
in a
light condition requiring
use of the flash.
The camera moved when
the shutter button was
pressed.
The subject was too
close.
There are water droplets
on the lens or the lens is
dirty.
The USB driver has not
been installed.
The power is off.
P. 57
P. 52
P. 57
–
P. 26
P. 52
–
P. 41
P. 157
P. 136
–
The camera is not recognized by the PC.