Olympus CAMEDIA AZ-2 ZOOM, Руководство для продвинутых пользователей

Страница: 153 / 177

The monitor is hard to see.
The battery run time is brief.
The picture is out of focus.
The date recorded with the image data is wrong.
The factory default settings are restored when the camera is turned off.
The flash does not fire.
153
If you encounter problems
9
Appendix
Possible cause Corrective action
Ref.
Page
Select a different flash mode (not flash off ).
If you want the flash to fire on a brightly
illuminated subject, set the flash to fill-in mode
.
The flash does not operate in the mode. Set
the mode switch to
.
Battery performance deteriorates in low
temperatures. Keep the camera warm by putting
it inside your coat or clothing.
When battery consumption fluctuates greatly, the
camera may turn off without displaying the
battery warning indicator. Charge the battery.
Aiming the camera at a bright subject in sunlight
may cause vertical lines to appear on the
monitor. This is not a malfunction.
Adjust the brightness in the SETUP menu’s
.
Block the sunlight with your hand.
Set the date/time in the SETUP menu’s . The
clock is not preset at the factory.
Set the date/time again.
Set ALL RESET to OFF in the MODE MENU.
Use focus lock to focus on the subject and then
shoot.
If the subject is closer than 30 cm (11.8"), use
the super macro mode.
The flash is set to the
flash off mode
.
The subject is brightly
illuminated.
The camera is in the
(movie) mode.
You are using the camera
in a cold environment.
The remaining battery
power is not indicated
correctly.
Vertical lines appear on
the monitor during
shooting.
The brightness is not
adjusted properly.
The monitor is exposed to
direct sunlight.
The date/time is not set.
The camera has been left
with the battery removed.
ALL RESET is set to ON.
Auto focus is not possible.
The subject is too close.
P. 52
P. 52
P. 10
–
–
–
P. 96
–
P. 97
P. 97
P. 82
P. 26
P. 41