33
R
AUCHWARNMELDER
SI 300
Installation Steps
Proceed as follows to install the smoke detector:
Warning
! Risk of serious injuries through damaging
cables or pipes! During installation, pay attention to
the possibility of cables and pipes running in the walls
and ceilings. We are not deemed liable for installation
errors. In case of doubt, contact a specialist!
1
Ensure that there are no electric cables, gas or water pipes near the installation
location.
2
Screw the base (1) to the ceiling at the chosen installation location using two screws
approx. 80 mm apart. (If necessary, use dowels as additional fixation material.)
3
Ensure that all the smoke detectors installed are connected by the way and means
necessary for your configuration.
4
Install the smoke detector on the base (1) and screw the smoke detector in the
direction of the arrow until it audibly locks in place.
You can only install the smoke detector on the base when a battery has been inserted in
the battery compartment on the rear of the smoke detector.
Disassembly of the smoke detector is performed in the reverse sequence.
