Olympia CDP 24201, Руководство пользователя

Страница: 14 / 50

Line selection buttons
These buttons enable you to select either of the two lines connected to your system. When a line is
selected, the LED below the relevant button will glow red. If a handset is using one of the lines, it will
already be glowing red and cannot be selected by the base station.
The line 1 select button will be shown as
The line 2 select button will be shown as
Control buttons
The base station control buttons are clustered to the left of the keypad
These control buttons perform as follows:
The and buttons control the base station's speaker volume.
The button is equivalent to flashing the hook switch on a corded phone.
The button pages all handsets registered to the base station and within range . When a
handset responds to the page, an intercom link is automatically established and the key
pressed to transfer the call.
The button glows red when pressed and mutes the base station's microphone during a call. This button
can also be used to locate and communicate with another Bluetooth™ device (see page 49 for details).
The button is also used to register handsets to the base station (see page 46 for details).
Speed dial buttons
The base station speed dial buttons are clustered to the right of the keypad
These buttons store and dial 4 pre-set speed dial numbers.
For more information about storing speed dial numbers, see page 39.
For more information about dialing speed dial numbers, see page 19.
Voice mail message indicators
The relevant indicator glows red when a message has been received on the respective phone line. This is
service provider dependant. Some service providers allow messages to be stored for you on their
equipment. These indicators show you there is a message waiting to be retrieved. Refer to your service
provider for details.
System controls & indicators
USER
GUIDE
www.olympiaphones.com
Page 15
mute
+
-
pa
r g tf
e/
ash l f
-
+
ash
l f
pa
r
g tf
e/
mute
pa
r g tf e/
mute
3
1
store 2 4