Page 5 from 5
923578007_09_003
LED MODULE CHARACTERISTICS
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
Olympia Electronics S.A.
50 °C max. across the board
Cable connection with polarity
11.6-14.4V DC
6.76W
2 2709153
GR-578/L/18/ST/WP
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72
nd
km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
[email protected]
A-1900
Test card
Manual TEST or Resetting Errors with the A-1900 Test card (not included and is available
only after request).
In order to test or reset the device you must place the card on the side of the
indications and remove it instantly for TEST or remove it after the reset is conducted (the
indications light in sequence).
LED INDICATIONS
Battery replacement
It can be done only by a competent person and after the mains interruption.
Step 1.
Remove the front cover by unscrewing the retaining screws. Remove the acrylic plate.
Step 2.
Unfasten the screws to remove the plastic cap and the battery’s plastic holder.
Step 3.
Remove the old battery and place a new on of the same type and characteristics.
Connect the battery’s cable as shown in the photo.
Step 4.
Replace the removed parts (previous steps 1,2).
2
3
1
