olympia electronics BS-1632, Руководство пользователя, Страница: 4 / 10

Page 4 from 10
RESOUND sirens: It is possible to configure to automatically resound the sirens following an alarm in another zone.
You must enter the technical code ( 364 ) and then press the key '4' .
The 'General fault' , 'General Disable ' and 'General alarm' LEDs start to blink. The Alarm LED of zone 2 led is off the
sirens resound following an alarm in another zone else if the led is on the sirens does not resound. By pressing the key
'5' you can change the configuration.
Programming the delay of general relay (AUX RELAY). If you want to program the delay of the AUX RELAY must
enter the technical code ( 364 ) and then press '6' . The LED " General fault " , " General Alarm " and “DELAYS ON”
begin to blink .
The indicative Zone "
A larm" and " F ault LED ” indicates delay activation of “ AUX RELAY ” .
To change the mode press ' 1 ' 2' , ' 3' and '4'. To exit the programming mode and store the settings in memory , press the
button <5 > . The system will automatically RESET and will enter normal operation .
Below is a table that summarizes all the code and corresponding functions.
921163600_09_022
Fault zone 1
Alarm zone 2
Alarm zone 1
Without
Delay
30 second
Delay
60 second
Delay
90 Second
Delay
LED ON
LED OFF
LED OFF
LED OFF
LED OFF
LED OFF LED ON
LED OFF LED OFF
LED OFF LED ON LED OFF
Fault zone 2
LED OFF LED OFF LED OFF LED ON
Code
3-4-4-4
3-4-5-4
3-4-5-5
3-4-5-6
3-4-6-4
3-4-6-6
3-6-4-5
3-6-4-4
3-6-4-6
Evacuate
Enable/Disable Zones
Function
Silence/Resound Sirens
Reset
Delays ON/OFF
Enable/Disable Sirens
Program AUX relay
Resound and Delay sirens
Program Predelay of AUX Relay
Fault zone 1
Fault zone 2
Alarm zone 1
Zero
Delay
Delay
1min
Delay
2min
Delay
3min
Delay
4min
Delay
5min
LED O N
LED Off LED Off
LED Off LED Off LED Off LED Off LED O n
LED Blink LED O ff LED O ff LED O ff LED O ff
LED O ff LED O ff LED On LED Blink
LED Blink
Program Siren delay. If we want to program the delay of the sirens we must enter the technical code ( 364 ) and then
press the key '4' . The 'General fault' , 'General Disable ' and 'General alarm' LEDs start to blink. The Alarm, the
Fault/Disable LED of zone 1 and Fault/Disable LED of zone 2 show the programmed delay of the sirens according to the
table below. By pressing the key '1' you can change the configuration.