Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 14
25.
Locate
Rear Top Plate
(3/4” x 2 1/2” x 73 3/4”) and position on wall flush to inside wall framing.
Align so angle cut on 33 3/4 degree end is facing the solid wall side and 22 1/2 degree end is facing
double window wall side.
Important: See Step 26
for Top Plate Angle alignment.
Rear T
op Plate
33 3/4 degree Top Plate end
flush with solid wall framing
24.
When all walls are attached together, check alignment with the floor. Bottom wall framing should
sit flush with outside floor framing. When positioned correctly, fasten bottom wall plates to floor using
4 - 2 1/2” screws per wall panel.
Important:
If walls are not lining up and appear higher or lower than
each other, your floor may not be LEVEL. Please check the level of your floor. You may need to make
slight adjustments to level your floor before proceeding.
Confirm 32” wide Door Opening prior to attaching walls to floor.
Angle
screws into perimeter
Floor Joists.
125 1/4”
125 1/4”
Bottom Wall
Framing
32”
Advice:
Prior to fastening walls and
installing rafters, take time to confirm your
walls are level, square and plumb.
Measure diagonal at top and bottom of
walls corner-to-corner. This should be
approximately 125 1/4”. More importantly, if
measurements are not within 1/4”, your
walls are not square. Adjusting now will
make it easier to do the roof section later
.
