Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 26
41.
Take the inside-to-inside measurment between
Top Wall Plates
and
Bottom Wall Plates
at the
front, middle, and rear of your shed. These measurments should each be approximately 136 1/2”, but
more importantly, if they are not within 1/4” of each other, your walls are not square.
136 1/2”
136 1/2”
136 1/2”
44.
Where
Ridge Boards
meet, press together and secure with
16 - 1 1/4”
screws
per side. We recommend using a clamp to hold the
Ridge Boards
together flush while screwing. Stagger screw position vertically on
Ridge
Board
to create a stronger connection. Complete both sides, Important: if there
is a gap between
Ridge Boards
, try pushing side walls closer together from
outside. Walls should be 136 1/2” apart at top from inside of wall plate to wall
plate as per
Step 41
.
Hardware (Steps 44)
S2
- 1 1/4” Screws
x 32 total
Advice:
It may be helpful
to use a clamp to help hold
Ridge Boards together
flush while screwing.
