28.
With Rafter Section correctly aligned, secure rafters to walls
using
2 - 90° Metal Brackets
per side. Attach each brackets with
4 - 1 1/4” Screws
. Screw into Wall Extension Framing at the rear
and Wall Panel top framing at the front. Complete both sides.
Hardware
Y2
- 90° Metal Bracket
x 4 total
S2
- 1 1/4” Screws
x 16 total
90° Metal Brackets
29.
With outside rafters properly secured, attach remaining interior rafters using
1 - 3” Screw
per rafter end. Screw into rafters from inside of Header on an angle at
front of shed, and from inside of Extender Wall Framing at rear of shed.
Hardware
S4
- 3” Screws
x 14 total
30.
There are 4 different plywood roof panel sizes required to
complete Start with an
Outside Large Plywood Panel
first.
Position so Plywood overhangs outside rafter by 2”. In the front,
plywood will be recessed 1/8” back from rafter end. With panel
positioned correctly, attach to rafters with
9 - 1 1/4” Screws
per
rafter.
Hardware (Steps 30 - 33)
S2
- 1 1/4” Screws
x 45 total
50” wide
48” deep
2” overhang
Recessed 1/8” back
from rafter end.
Parts (Steps 30 - 33)
3F
- Large Roof Panels - Outside
(5/8” x 48”d x 50”w)
x 2
3G
- Large Roof Panel - Center
(5/8” x 48”d x 45 1/2”w)
x 1
3H
- Small Roof Panels - Outside
(5/8” x 5 3/4”d x 50”w)
x 2
3I
- Small Roof Panel - Center
(5/8” x 5 3/4”d x 45 1/2”w )
x 1
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 20
