Olsberg OEC, Инструкция по эксплуатации

Страница: 32 / 68

32
Instructions air regulator operation
Press M until 100 appears on the display and -manual
mode- (arrow on bottom left of display) illuminates
in intervals.
Press P 2x = move air regulator from 100 to 95%
Press P 1x = air regulator closes in 5% increments
each time
Press
M
1x = air regulator opens in 5% increments
each time
The air regulator can be opened or closed in 5% incre -
ments by pressing the P or M buttons.
Press R to change back to automatic mode once again
→ A new combustion cycle is started.
→ The air regulators open completely.
→ Shown in display = 100
Operator‘s menu
The following settings can be made in the operator‘s
menu:
● Primary air shut-off time 1 - 60‘
● Select control curve 1 - 4
● Acoustic signal on/off
● Display brightness
● Display on/off when motor active
● Code word change
Change primary air shut-off time
with sub-menu PAS
Press
P
until
PAS
appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until C - S appears in the display.
Press R = 15 in display (for control curve 2)
Set the desired value with P or M .
Press R to confirm.
Press P + M simultaneously to exit the menu.
Select control curve with sub-menu tYP
Press P until PAS appears in the display.
Press
R
=
0
in display
Press
P
until
-2
(code word) appears in the display.
Press
R
=
PAS
in display
Press P until tYP appears in the display.
Press R = 2 in display
Set the desired value with P or M .
Press R to confirm.
Press P + M simultaneously to exit the menu.
Acoustic signal on/off with sub-menu bEP
Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until bEP appears in the display.
Press R = on or off in display
Set the desired value with
P
or
M
.
Press
R
to confirm.
Press P + M simultaneously to exit the menu.
Change display brightness with sub-menu JAS
Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until JAS appears in the display.
Press R = 0 - 5 in display
Set the desired value with P or M .
Press R to confirm.
Press P + M simultaneously to exit the menu.
Display on/off when motor active
with sub-menu Sut
Press P until PAS appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until Sut appears in the display.
Press R = on or off in display
Set the desired value with P or M .
Press R to confirm.
Press P + M simultaneously to exit the menu.
Code word change with sub-menu EPS
Press
P
until
PAS
appears in the display.
Press R = 0 in display
Press P until -2 (code word) appears in the display.
Press R = PAS in display
Press P until EPS appears in the display.
Press R = -2 in display
Set the desired value with P or M .
Press R to confirm.
Press P + M simultaneously to exit the menu.