WARNING! No-Slip Security Straps have been included to help stabilize this Ol’ Man Multi-Vision Treestand. They
must be engaged after reaching climbing height! Failure to follow these instructions may result in serious or death!
WARNING! You must disengage the No-Slip Security Straps prior to attempting to climbdown. Failure to follow these
instructions may result in serious or death!
OL’ MAN TREESTANDS MULTI-VISION CONNECTOR STRAP
Your new stand is equipped with a 1-inch wide “Connector Strap” (H.) (Refer to Figure 1).The purpose of this strap is to connect
the standing platform A.) to the seating platform (B.). During use, should the standing platform (A.) inadvertently slip off the
user’s feet, the “Connector Strap” (H.) will keep the platform from slipping down the tree. Should the standing platform (A.)
inadvertently slip-off your feet during use, retrieve it by simply pulling on the “Connector Strap” (H.). DO NOT modify or
disconnect this “Connector Strap” (H.) for any reason.
WARNING! A connector strap has been factory installed for your safety. It is for the express
purpose of connecting the standing platform to the seating platform. DO NOT modify or
disconnect this connector for any reason. Failure to follow these instructions may result
in serious or death!
INSTALLING OL’ MAN MULTI-VISION TREESTAND
WARNING! Prior to attempting to use this or any other Ol’ Man Treestands product(s) you must take a moment and
become familiar with it’s setup and installation at ground level. You must practice installing, setting-up and using this
product(s) at ground-level prior to attempting to use it at heights above ground-level. Once you have become
thoroughly knowledgeable and comfortable with this Ol’ Man Treestands product(s) setup, installation and use at
ground-level - you’re now ready to use it at heights above ground-level. Failure to follow these instructions may result
in serious injury or death!
WARNING! STOP NOW!!!!! Make sure that you are wearing your full-body fallarrest
harness! Failure to follow these instructions may result in serious injury or death!
WARNING! Never attempt to hunt from an unlevel standing and/or seating platform. Additionally,
NEVER attempt to level your standing and/or seating platform at heights above the ground. Failure to follow these
instructions may result in serious injury or death!
WARNING! If you find that your platform(s) is unlevel, canted, angled awkwardly upward or
downward - YOU MUST SELECT ANOTHER TREE TO INSTALL YOUR TREESTAND! NEVER
ATTEMPT TO HUNT OUT OF AN UNLEVEL TREESTAND! Failure to follow these instructions
may result in serious injury or death!
STEP 1: Select a straight, healthy tree between 9 to 20-inches in diameter.
WARNING! This Ol’ Man Treestands treestand is designed for climbing trees with a
minimum diameter of 9-inches and a maximum diameter of 20-inches. Attempting to
climb trees outside of this range puts the user at serious risk of bodily injury or death.
Failure to follow these instructions will result in serious injury or death!
STEP 2: Place the standing platform (A.) (Refer to Figure 1) approximately 12-inches off the
ground on the base of the tree. Wrap the cable assembly (C.) around the back of the tree trunk
and slip the cable assembly (C.) into the spreader arm (D.) and insert the cable locking pin (E.)
(Refer to instructions on Page 6, Figures 2-5 for detailed cable locking pin operation). Make
certain the expanded metal surface is facing upwards and the spreader arms (D.) are vertical as
shown in Figure 17.
WARNING! Care must be taken to ensure that the cable locking pins have engaged
the cable assembly ends. Once the cable locking pins have been installed, pressure
should be applied to both the standing platform as well as the seating platform prior
to climbing to ensure that the cable locking pins have indeed engage the cable
assemblies. Failure to follow these instructions may result in serious or death!
