E-
14
19. Push the lever pulled in step 17 back to its origi-
nal position. Align the mounting hole on the lever
with the screw hole on the finisher, and then
screw the lever to the finisher (one furnished
mounting screw).
Note:
The mounting hole on the lever must overlap with
the screw hole on the finisher.
* If the mounting hole on the lever does not overlap
with the screw hole on the finisher, take the fol-
lowing steps (1) to (9).
(1) Disconnect the two connectors and remove the
cord clamp. Remove the finisher from the main
body.
(2) Remove the lower front cover from the finisher
(two screws).
(3) Remove the cover from the caster located on
the front side of the finisher (one screw).
(4) Remove the rear cover from the finisher (ten
screws).
(5) Remove the cover from the caster located on
the rear side of the finisher (one screw).
A0HRIXC031DA
Screw hole
Mounting hole
on the lever
A0HRIXC040DA
A0HRIXC032DA
A0HRIXC033DA
A0HRIXC034DA
A0HRIXC035DA
Installation Manual
Y111090-1
