Management
10-15
10
Obtain NW User Property
Set the required information to obtain the network user property from the LDAP server.The user name and
e-mail address obtained with this setting is shown in the user information, the status confirmation screen, and
the header of e-mail.
NOTE:
To obtain the network user property from the LDAP server, [Network Authentication] must be selected
for the authentication method in
User Login on page 10-2
. Select [On] for LDAP in
Protocol Detail on page 9-
94
.
The table below explains the required information to be registered.
*1
If using Active Directory of Windows, the server name may be the same as the server name entered in the
network authentication.
*2
If using Active Directory of Windows,
displayName
of Attribute may be used as
Name 1.
*3
Name 2
can be left out. When you assign
displayName
in
Name 1
and
department
in
Name 2
, and if the
value of
displayName
is "Mike Smith" and the value of
department
is "Sales" in Active Directory of Windows,
the user name appears as
Mike Smith Sales
.
*4
If using Active Directory of Windows,
of Attribute may be used as
E-mail Address
.
*5
Appears when the server type is set to "Kerberos" in "Network Authentication".
Use the procedure below.
1
Press the
System Menu
key.
2
Press [User Login/Job Accounting].
3
If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. Refer to
Adding a User
(Local User List) on page 10-5
for the default login
user name and password.
Item
Description
Server Name*
1
Enter the LDAP server name or the IP address (up to 64 characters). If a server
name is not entered, user information will be acquired from the server set for
Network Authentication.
Port
Set the LDAP port number or use the default port 389.
Name 1*
2
Enter the LDAP Attribute to obtain the user name to be displayed from the
LDAP server (up to 32 characters).
Name 2*
3
Enter the LDAP Attribute to obtain the user name to be displayed from the
LDAP server (up to 32 characters).
E-mail Address*
4
Enter the LDAP Attribute to obtain the e-mail address from the LDAP server (up
to 32 characters).
Authenticat Type*
5
Set the authentication method. Select [Simple] or [SASL]. After changing the
setting, restart the system or turn the power off and then on.
Search Timeout
Set the amount of time to wait before time-out in seconds (from 5 to 255
seconds).
LDAP Security
Select the type of encryption according to the type of security employed by the
LDAP server. The default setting is
OFF
.
Содержание d-COPIA 3500MF
